Diy Metal Roof Snow Guards

Snow rails vary in their material.

Diy metal roof snow guards. This was 1 year ago they have been through one winter and are still all attached and the roof didn t collapse have now installed the below gutter heat tape h. There are plastic metal individual pad style snow guards that have to be glued to the roof panel in which the glue will have a certain holding strength that is less than a mechanically attached option. There are clamps on snow guards that attach to the standing seam ribs and use set screws to mechanically attach. The snow diverter holds the snow above the roof penetration and prevents excessive snow loads.

Place the guard in a staggered formation so that every other guard is 6 inches higher up on the roof. Then to reinforce it use the power drill to screw each board onto an asphalt or wood roof. Typically snow guards are made of stainless steel zinc coated steel copper or aluminum but sometimes they come in polycarbonate and plastic. The lmcurbs snow diverter is designed to divert the snow and ice away from stacks and vent pipes on metal roofs to avoid damage.

Our metal roof snow guard products are a cost effective long lasting aesthetically pleasing snow retention solution for any metal corrugated standing seam asphalt shingle or slate roof located in a winter climate. Use the silicone caulk make a ring on the bottom perimeter of the board then put in place on the roof. For shingle roofs use a thinner board and slide it under the shingle after you have loaded it with caulk.